After my first experience with the Cannondale Cujo 1 bike, I noticed that the handlebars were too wide compared to my previous GT Avalanche 1.0.
I tried to get used to it over the years, but finally decided to cut the handlebars.
Before cutting I measured the width (with grips):
It is about 765mm.
At first I wanted to use a hacksaw, but then I remembered that I have a tube cutter (from a tool set).
The tube cutter is suitable for the diameter of the handlebars.
Cutting the handlebar with the tube cutter:
The result after cutting and before processing with a file:
Cut-off parts:
The width (with grips) after cutting:
It is about 730mm. I like this width more than the stock one.
See also related notes:
- Cannondale Cujo 1 (2018): впечатления от первых поездок (2018-10-21)
- Мой новый велосипед: Cannondale Cujo 1 (2018) (2018-10-06)
- Suzuki Jimny: тормозные магистрали (практика-1) (2013-11-12)
0 comments:
Post a Comment